Parallel port

From open-encyclopedia.com - the free encyclopedia.

In computing, a parallel port is an interface from a computer system where data is transferred in or out in parallel, that is, on more than one wire. A parallel port carries one bit on each wire thus multiplying the transfer rate obtainable over a single cable (contrast serial port). There are usually several extra wires on the port that are used for control signals to indicate when data is ready to be sent or received.

This type of port is most often used by a microprocessor to communicate with peripherals. The most common kind of parallel port is a printer port, e.g. a Centronics port which transfers eight bits at a time. Disks are also connected via special parallel ports, e.g. SCSI, ATA.

The parallel port of an IBM-PC compatible is the only standard computer peripheral that brings standard computer logic voltages directly out to a set of pins. It is much beloved by experimenters and engineers who often use it for inexpensive computer controlled projects. Standard logic voltages are virtually harmless: five volts (roughly the same as two run-down flashlight batteries), and ground (zero volts).

The connector is rather bulky and has 25 pins, the wire is also pretty thick.

Some examples of parallel ports:

• IEEE 1284 is the IEEE standard for the common PC printer port.
• 8255 for Intel microprocessors
• Z80PIO for Zilog microprocessors

Port addresses

Traditionally IBM PC systems have allocated their first two parallel ports according to the configuration in the table below.

See also

• Serial port
• Port

References

http://www.fapo.com/porthist.htm - Warp Nine Engineering: history of the parallel port